|
|
| Power
Supply |
powerStation 1000VC/1000XP
|
AE-8450 / 8750 |
 |
|
Electrophoresis use power supply. Up to 1000V constant voltage, up to 500mA
constant current, up to 1000-minute timed run and automatic crossover (in
addition, AE-8750 offers 200 Wattage constant output), 10 sets of
voltage-current-time conditions, programmed, stored and easy accessed.
Safety-protective automatic output shutdown to prevent operations from
electric hazard. 2.5Kg light compact design. Easy to operate control panel
with large and bright 4-digit LED display to read either set or actual
conditions. Convenient output pause function for temporary interruption or
resetting. Minimized electrical noise for other lab instruments. Power
failure protection. |
| myPower 300/500 |
AE-8130 / 8150 |
 |
| 7cm wide,
14.8cm high and 21cm deep small compact and lightweight electrophoresis use
power supply. AE-8130 myPower 300, providing 300V and 400mA constant output
with automatic crossover, suits horizontal agarose electrophoresis, semi-dry
blotting and PAGE with up to 50VA output. AE-8150 myPower 500, providing
500V and 200mA constant output with automatic crossover, suits PAGE,
horizontal agarose electrophoresis, mini semi-dry blotting with up to 25VA
output. Up to 999 minutes timed output with alarm buzzer. User-friendly
simple and easy operation. 2-line, 3-digit meter allows reading either set
or actual voltage, current and time, during output. Convenient, dual power
outlet in parallel. Safety shutdown against short and open circuit.
|
| constaPower 3000 |
AE-8800 |
 |
| Power supply
for electrophoresis in which the output of up to 3000V voltage is possible .
Up to 3000V constant voltage, up to 300mA constant current, up to 300W
constant output, up to 99999-minute timed run and automatic crossover.
Safety design. As it offers wide range of voltage, current and wattage, it
suits disk, mini-slab/slab PAGE, submerged agarose electrophoresis, SSCP,
IEF etc. |
| CrossPower 150
(NOT available for 220-230V) |
AE-8300 |
 |
| Power supply
equipped with "Crossover ability" and it has the large current specification
in which the current output up to maximum 4A is possible. Output ranges are
up to 150V and up to 2A, or up to 75V and up to 4A . Automatic crossover
function to lessen heat interference to separation, damage to gel and danger
to operator. Reliable output stabilized against variations in voltage, load
and temperature. It suits for the cases needed large current with relatively
low voltage, such as submerged agarose electrophoresis, semi-dry blotting
in large gel format and Tank blotting. |
| Gel
Photography and Picture Analysis |
Printgraph |
AE-6914/6911 |
|
| Gel
documentation system consisting of a high sensitivity monochrome CCD camera,
a various functions camera controller and a shading cabinet. Real-time
photography of a sample is possible. There are two types of camera
controllers, the one has picture saving function to Floppy Disks, the other
dose not have. The shading cabinet is chosen from four types (FX type: good
at gel extraction and easy handling, CX type: provided with light inside, DX
type: small and low price, stand type: used in darkroom ) according to the
purpose of use, the kind of sample, and the size of gel and cabinet.
|
Densitograph
(#English version under development) |
AE-6920 M/V |
 |
System which
photos and saves electrophoresis gel patterns, and performs quantification
from a stained image using picture analysis software. It's constituted of
"Printgraph", a personal computer (Windows), and analysis software.
- Molecule-weight-presumption from the position information of molecular
weight markers by "Zone-densitometry" method is possible.
- Concentration quantification from the acquired accumulated value by
measuring the band is possible.
- Plural spot quantification of 2-dimensional electrophoresis patterns
is possible by the method of "Spot measurement".
- Dot-blot patterns arranged regularly can be measured at a time by the
method of "Plate measurement".
|
Electrophoresis
Peripherals |
Staining and Destaining |
Automatic Gel Stainer |
AE-6610 |
|
| Designed to
minimize operator's load as well as to provide higher reproducibility with
technical consistency, by automating staining routines. Operation
programmable for staining with reverse stain or silver stain, for staining
and destaining with dye stain or ethidium bromide, for staining of blot
membranes, and various staining techniques. Up to 9 files to program and
store your staining protocols. Up to 20 steps per file to program a series
of procedures. |
| Gel Staining Reagent |
Silver Stain kit |
AE-1350 |
|
| High
sensitivity band detection reagent kit after gel electrophoresis of protein
and nucleic acid. Easy handling and the dyeing processing time is 50 - 55
minutes. The reagent includes pure water and four kinds of liquids. One
dyeing reagent kit can dye about 50 mini-gels. |
| Reverse Stain kit |
AE-1300 |
|
| High
sensitivity and high speed band detection reagent kit after gel
electrophoresis of protein. sensitivity of coloring is 10 times higher than
conventional ones. Detection time is about 20 - 25 minutes. A reagent
includes pure water and three kinds of liquids. One dyeing reagent kit can
dye about 50 mini-gels. |
| Gel Dryer |
RapiDry |
AE-3750 |
|
| Dual-Heater
Gel Dryer. It has a 45 x 38cm wide gel drying area, which accommodates 1 or
2 sequencing gels, up to 6 PAGE gels, or up to 12 mini PAGE gels to be dried
simultaneously. Dual-heater (one in the lid and one in the base) affords
rapid drying and ensures even heat distribution. It provides 40 to 80°C
temperature adjustment. 3-speed initial-temperature-rise selectable for
delicate gels. Up to 540 minutes timer. Simple and easy operation.
|
| RapiDry mini |
AE-3711 |
 |
| Gel drying
area : 20 x 19cm. Dual-heater (one in the lid and one in the base) affords
rapid drying and ensures even heat distribution. Compact, easy-to-operate
design. Fluoroplastic-coated heat panel. Full protection against overheat.
40 to 80°C temperature adjustment. Up to 180 minutes timer. |
| GELMASTER |
Model-1426 |
 |
| The vacuum
pump for gel dryer. It's connected directly to a gel dryer with a connecting
tube, and absorbs. It is not necessary to connect other traps such as a
cooling trap. Easy handling, maintenance and space-saving because of compact
design. |
|
Electrophoresis Set / System |
Mini-slab Electrophoresis set
|
AEP-801 |
|
|
A basic
set of mini slab polyacrylamide gel electrophoresis of protein and DNA. You
can start your experiment immediately after getting this system with precast
gel.
[Composition]
mini PAGE Chamber / PAGEL precast mini gel / Power Station 1000VC
|
| Wide submerged agarose EP* set
|
AEP-850 |
|
|
Agarose
electrophoresis of maximum of 108 samples is possible for separation of DNA
or the analysis of PCR-amplified fragments,
[Composition]
Submerged Agarose Electrophoresis (AE-6135) / Power Station 1000VC
*EP:
ElectroPhoresis |
| Multi-42 submerged agarose EP
set |
AEP-851 |
|
|
Agarose
electrophoresis using large gel with the width of 20cm and 21/42 samples for
separation of DNA or the analysis of PCR-amplified fragments.
[Composition]
Submerged Agarose Electrophoresis (AE-6133) / Power Station 1000VC
|
| Multi-30 submerged agarose EP
set |
AEP-852 |
|
|
Agarose
electrophoresis using long gel with the length of 20cm and 16/32 samples for
RFLP
[Composition]
Submerged Agarose Electrophoresis (AE-6125) / Power Station 1000VC
|
| miniQuencer standard set |
AEP-860 |
|
|
PAGE
with the gel size of 18x20cm for SSCP or differential display or nucleic
acids.
[Composition]
miniQuemcer (AE-6141E) and miniGeling (AE-6141M: gel casting
apparatus) / constaPower 3000 |
